The new Rite Spec is your next favorite airframe. Engineered to compete in the FPV Wing Racing Association's Spec Wing class...but at a much higher level of performance. This aircraft will lead the pack at your local field and still conform to today's competition constraints. Don't get left behind with all the rest. It's time to fly the best.
Version 3 airframes lack center-mount fins, further conforming to class racing rules.
A note on power systems: The official WRA Spec-Class motor (Cobra Champion Series 2210 2200kv) is run on 3S with a 6x4E prop when in competition. This setup makes for fun general flying. If you would like to run the system on 4S for more speed, we recommend propping-down slightly to a 5.5x4.5E or 5x5E propeller.
Specifications
Wingspan: 36"
C.G. target is located 6 3/4" (171mm) rearward from the tip of the nose.
Balsa cross-section: 1-1/2" x 3/8"
Includes
EPP Wing with spar slots
Equipment and battery bays
Servo bays and recesses already cut
Vertical Stabilizers, wing fences and skids
Bay Lids, top
Bay floor, bottom
Servo floors
Wooden Elevons
Hardware
Motor Mount
Fiberglass Spars
Required to complete
Control hardware
Laminate
All electronics
Recommended Accessories
3S (competition) battery: 2200mAh
4S (sport) battery: 1800mAh