Orders shipped Monday-Friday from Arcadia, California.

Matek Systems 1.2/1.3 GHz 800mw Video Transmitter

Your Price: $44.99
Out of Stock.
Part Number:MTK-VTX-1G3SE
Wide voltage input range, Adjustable power output levels, CMS control via Tramp protocol variant

WARNING
Powering on without antenna connected will damage the RF module !!!
This product requires an amateur radio license to operate legally. Please check your local laws and regulations before purchasing

This is the 2 Channel US Version.  It has identical hardware and layout to the international version, but is locked to 1258 & 1280 MHz channels by firmware.

Features & Specifications
SKU: VTX-1G3SE-2
2CH_US version (1258MHz & 1280MHz),  

RF power output: 0.1mw(0, pit mode), 25mw(1), 200mw(2), 800mw(3)
CMS control via Tramp protocol variant for 1.3G
Button control and LED indicators
Built-in AGC microphone
6-36V DC IN (2-8S LiPo)
Power Consumption: 40mA(0.1mw), 110mA(25mw), 150mA(200mw), 250mA(800mw) @12V IN
Video format: NTSC or PAL
Audio Subcarrier: 6.5 MHz & 6.0MHz,  onboard microphone on 6.5MHz
RF Connector: SMA
Weight: 9g ( w/o antanna)
Size: board 36*21.5mm

Pads
+ IN-: 6-36V DC input with reverse polarity protection
VID: Video input
G: Ground
5V: onboard regulator output, Max. 1.5A load on this pad
A6.0: Audio 6.0MHz input
RX: CMS control via Tramp protocol
TX & RX: UART for firmware update

Packing
1x 1.2/1.3G Video transmitter VTX-1G3SE-9(INTL version) or VTX-1G3SE-2(US version)
1x Dipole antenna_SMA, center freq 1240MHz

Settings
Press button-A to select RF output levels, 0 (blue LED)= 0.1mw pitmode, 1=25mw. 2=200mw, 3=800mw
Press and hold the button-B for 2 seconds to enter the frequency setting. Frequency LED blinks
Press the button-B to select the frequency (only 1258 and 1280 can be selected on US 2CH version)
When the LED blinks at new frequency, no RF output on this frequency.
New frequency and output will be enabled if no button action within 3 seconds

CMS control
Connect “RX” to any spare UART-TX of flight controller,  enable “VTX(Tramp) protocol” on corresponding UART.
Copy and paste following command into CLI of BF4.1 or later release

vtxtable bands 2
vtxtable channels 8
vtxtable band 1 1G3_A A 1080 1120 1160 1200 1240 1280 1320 1360
vtxtable band 2 1G3_B B 1080 1120 1160 1200 1258 1280 1320 1360
vtxtable powerlevels 3
vtxtable powervalues 25 200 800
vtxtable powerlabels 25 200 800

When CMS control is enabled, button control will be overridden.

Only 1258 and 1280 can be enabled via CMS control on 2CH version.

Related Items

 
 
 

Accessories

TrueRC Singularity 1280 V2 Side Feed SMA
$19.99
In Stock.
 
 

Recently Viewed Items