Some pilots still prefer separate ESCs, as opposed to running all-in-one ESC units. For these pilots, the RADIX 2 Power Board (PDB) is a dream come true!
BrainFPV RADIX 2 30 x 30 Power Board (PB)
Designed for serious power, the RADIX 2 PB can handle up to 8S (35 V) input voltage and up to 160 A constant current / 220 A burst current. The RADIX 2 flight controller stacks directly onto it and is plug-and-play using the included cable. The PB has a LC filter to provide clean, filtered battery voltage to the flight controller to power it. In addition, it has a 5 V / 2 A voltage regulator to power accessories like LED’s. The 5 V regulator can optionally be switched to 10 V and can e.g. be used to power a digital FPV system.
Note: The RADIX 2 PB is NOT plug-and-play with the original RADIX (F4 based) flight controller. It can be used with the RADIX, but it requires removing the “PWR wire” from the connector. Please refer to the manual for how to do so.
RADIX 2 Power Board
10-pin cable for connecting RADIX 2 flight controller
Capacitor (330 uF, 50 V)
Plug-and-play with RADIX 2 flight controller using included 10-pin cable
Up to 8S (35 V) battery voltage support
Designed to handle 160 A (220 A burst) total current to motors
Integrated current sensor (current scale: 100, 10 mV / A)
Integrated LC filter for clean power to flight controller
Integrated 5 V / 2 A voltage regulator. Can be switched to 10 V for powering a camera or a digital FPV system
Size: 49 x 49 mm (30.5 mm hole spacing)